DM1W2-5650V - Zippy DM1W2-5650V Power Supply

DM1W2-5650V - Zippy DM1W2-5650V Power Supply - N1 Redundant 650W Simple Type:...

Zippy DM1W2-5650V Power Supply - N1 Redundant 650W Simple Type: Power Supply

For Resellers and High Volume Orders:
Please request a quote to obtain preferred pricing.

As logic level is low, outputs voltage were enable, as logic level is high, outputs voltage were disable.
Cooling: two 38x38x28mm dc fans
Dc inlet in each module
Dielectric withstand: input/output 1500 vac for 1 minute input to frame ground 1500 vac for 1 minute
Efficiency: 80% typical, at input -48v full load
Emi: fcc class a , cispr 22 class a
Hold up time: 1ms min. At full load
Over current protection:+5v,+12v,+3.3v
Over power protection: 110~150% max
Over voltage protection: +5v-5.7v~6.5v, +3.3v-3.9v~4.3v, +12v-13.3v~14.3v
Power good signal: on delay 100ms to 500ms, off delay 1ms
Remote on / off control
Safety: to meet ul, cul, tuv
Temperature range: operating 0C~60C, storage -20C~80C
The unit shall accept a logic open collector level which will disable/enable all the output voltage (exclude +5v stand by).

General

+12V1 VDC: Output Current Min:2 Output Current Max:50.00 Output Current Peak:- Regulation Load:±5% Regulation Line:±1% Output Ripple & Noise Max:120mV
+3.3 VDC: Output Current Min:0.5 Output Current Max:36.00 Output Current Peak:- Regulation Load:±5% Regulation Line:±1% Output Ripple & Noise Max:50mV
+5 VDC : Output Current Min:0.5 Output Current Max:32.00 Output Current Peak:- Regulation Load:±5% Regulation Line:±1% Output Ripple & Noise Max:50mV
+5 Vsb DC: Output Current Min:0.1 Output Current Max:3.50 Output Current Peak:- Regulation Load:±5% Regulation Line:±1% Output Ripple & Noise Max:50mV
-12 VDC: Output Current Min:0.05 Output Current Max:0.80 Output Current Peak:- Regulation Load:±5% Regulation Line:±1% Output Ripple & Noise Max:120mV
Input (PS): VOLTAGE: -36 ~ -72 VDC, NORMAL -48VDC INPUT CURRENT:17A(RMS)FOR -48VDC INRUSH CURRENT:30A AT -48VDC (AT 25 DEGREES AMBIEND COLD START)